safety gear

英 [ˈseɪfti ɡɪə(r)] 美 [ˈseɪfti ɡɪr]

网络  安全钳; 安全棘轮; 安全钳装置; 安全装置; 安全机构

化学



双语例句

  1. The pair scaled the 632m skyscraper without any safety gear and got so high they passed through clouds on their way up.
    这两人没有任何安全保险措施,穿过缭绕的云雾,徒手攀上了632米的高楼。
  2. They rarely use safety gear, and share images of themselves online.
    他们几乎不使用安全装置,拍摄的图片都会在网上分享。
  3. He first swam Rosie ashore safely before returning for his wife, whose safety line had snagged on the steering gear, McGregor added.
    麦格雷戈补充说:他先抱着罗西游到岸边,确认它安全后才回到妻子身边。当时他妻子的保险绳被勾在了船舵上。
  4. Only a fraction of one per cent of labourers in the country use safety gear when applying pesticides.
    印度只有1%的劳动者在施用农药的时候佩戴安全装备。
  5. Dynamics Analysis and Safety Design of Locomotive with Lateral Coupling Device; transversing gear
    采用横向连接装置机车的动力学分析及安全性设计
  6. We bend ourselves to seek the optimization solution for rope gripper, speed governor and high-powered safety gear.
    公司自始创以来,集中于夹绳器、限速器和高性能安全钳的优化解决方案。
  7. Modeling and Deformation Analysis of Elevator Rail With Duplex Safety Gear
    双安全钳作用下的电梯导轨建模与变形分析
  8. Grill and waffie-iron, combined, electric Modeling and Deformation Analysis of Elevator Rail With Duplex Safety Gear
    组合式电动栅形烤架和蛋奶烘饼铁钳模双安全钳作用下的电梯导轨建模与变形分析
  9. Adjusting safety device for hydraulic system of steering gear ( windlass 、 mooring winch).
    后部液压遥控操舵装置舵机(机、缆机)压系统安全装置调整。
  10. But further safety measures, including head gear that would lessen the impact of any knock to the head, might be warranted, he said.
    但将来可能会出现一些保护装置,比如可以用来减轻撞击对头部影响的头部装备,他说。
  11. Based on the model of multi-span slender rod, the moment equations and deflection equations of elevator rail with duplex safety gear were established and resolved in a complex state of stress.
    结合双安全钳作用特点,以多跨度细长杆模型为基础,建立并求解了电梯导轨在复杂受力状态下的弯矩方程和挠曲线方程。
  12. The government temporarily closed another mine after men were forced to work underground without safety gear and boots.
    有一家矿厂条件很差,矿工被逼着在没有矿靴和安全的升降设备的情况下工作,政府被迫将它(矿厂)关闭了。
  13. Study on System Safety Analysis Methods of the Main Landing Gear System
    主起落架系统的系统安全性分析方法研究
  14. If the car has no starting safety switch, it is possible to spin the engine with the transmission in gear.
    如果没有安全启动开关,启动系统很可能在挂挡后工作。
  15. The safety switch can be an electrical switch that opens the control circuit if the car is in gear.
    安全开关可以是一种电子开关,当汽车挂挡后,它断开控制电路。
  16. Bilayer gears, crown gears, bevel gear, wheel, Helical, Worm, safety clutch teeth, small modulus gear and steering gear copper server.
    双层齿轮、皇冠齿轮、伞齿轮、滚轮、斜齿、蜗杆、安全离合齿、小模数铜齿及舵机伺服器等。
  17. The parameters, such as deviation, idle motion time, and the gap of brake-shoe could be found from the test curve, they are the important factors influencing the safety of the arresting gear and the important items of the performance test of the braking system.
    同时在测试曲线中可以得到制动盘的偏摆、空动时间、闸瓦间隙等参数,这些都是影响制动器安全的重要因素,也是制动系统性能测定的重要内容。
  18. Safety Factor in Power Rating for Gear Design
    齿轮设计中的强度安全系数
  19. The Surface Fatigue Strength and Safety Factor of W N Gear
    双圆弧齿轮的接触疲劳极限与安全系数
  20. Limit Range of Braking Distance for Anti-falling Safety Device the Gear Cone Drum
    齿轮锥鼓形防坠安全器制动距离的限制范围
  21. In order to utilize full power of motor, the Authors propose to multiply the maximum torque of motor by a coefficient of safety to meet the corresponding maximum torque of windlass or steering gear.
    为了充分利用电动机的潜在能力,建议以电动机的最大转矩乘以裕度系数来适应起锚机和舵机所需要的最大转矩。
  22. Because the formula contains such factors as material property, safety allowance and gear ratio which may influence tooth number, it can make design result more satisfactory and more convenient to control.
    此公式同时考虑了材料性能、安全裕量及传动比等多因素对选择齿数的影响,使设计结果趋于优化、便于控制。
  23. The methods for calculating the diameter of safety pin, fit clearance between the sleeve and hole in the planetary gear, and the quantity of the lubricants filled in the gear mechanism are presented.
    给出了安全销直径、行星轮轴套与行星轮孔的配合间隙及机构润滑油加注量的计算方法。
  24. Through simple introduction about the structure braking principle and detection technique of anti-falling safety device with gear cone drum, this paper mainly discusses the familiar problem, analyzes some familiar breakdown examples.
    本文通过对齿轮锥鼓形渐进式防坠安全器的结构、制动原理及检测技术的简要阐述,着重对检测中的常见问题进行探讨并对一些常见故障进行分析。
  25. The Assess on Safety Life 、 Durability and Damage Tolerance of Main Gear Strut Cylinder
    主起支柱外筒疲劳耐久性及损伤容限评估
  26. AR4 automatic transmission is a full electrical controlled hydraulic one, enjoys the fault self rerifying function and has a safety gear.
    AR4自动变速器为全电控液压自动变速器,具有故障自检功能并设有安全档位。
  27. To insure the operation of cables in safety and in gear, there is an interest in accurate methods for predicting the thermal behavior of underground cables.
    考虑到地下电缆的高额投资,为确保电缆能够安全、正常地工作,采用精确的方法预计地下电缆的热特性是很有必要的。
  28. It is very important to patrol in transformer substation, in order to keep the production and safety in gear.
    变电站的巡检工作在保证变电站正常生产、安全运行方面占有极其重要的地位。
  29. With the development and application of gear pump in high temperature, high pressure, large displacement, low flow pulsation and low yawp. It is necessary for us to study the characteristics and improve safety and efficiency of gear pump.
    随着齿轮泵在高温、高压、大排量、低流量脉动、低噪音等方面发展及应用,对齿轮泵的特性研究及提高齿轮泵的安全和效率已成为各国深入研究的课题。
  30. At the same time, through the gear strength calculation and found that idler gear bending fatigue factor of safety was less than the minimum, which could easily lead to fatigue damage th the gear.
    同时,通过齿轮强度计算,发现惰齿轮弯曲疲劳安全系数低于最小值,易造成齿轮的疲劳破坏。